Why water is more dangerous than the frost itself
Blocks and fresh mortar cope well with low temperatures as long as they are dry. Water that soaks into a wall freezes and expands. A few freeze–thaw cycles are enough for the mortar in the joints to start crumbling and the edges of blocks to spall.
The Sejny and Suwałki area lies in the coldest ground-frost zone in Poland, and frost can hold for weeks. That is why every hour spent in autumn draining water from the site saves days of work in spring.
Wall tops and the floor slab
The most exposed parts are the tops of the walls. Rain and melting snow get in from above and run down inside the blocks. Cover them with building sheeting or roofing felt folded down the sides of the wall and weigh it down with planks or blocks so the wind does not tear it off.
Water should not stand on a slab without a roof. Clear snow after heavy falls and check that nothing blocks the drainage through the openings. If the roof is already on, inspect the flashings around chimneys and roof windows — in winter a leak is only noticed once the walls get damp.
Windows, doors and ventilation
Window and door openings in an open shell are protected from snow with sheeting or boards. Do not seal the building tight, though: after the season the walls are still releasing moisture and need air movement. Leave gaps or a few uncovered openings on the sheltered side.
Foundations and the ground around the building
Footings and foundation walls with open trenches around them are best backfilled before winter, or at least protected from flooding. Water collecting in a trench by the foundation freezes and can heave the ground, and waterproofing without backfill is easily damaged.
If the foundation walls already have extruded polystyrene insulation, check that the boards are pressed in and covered. Exposed polystyrene degrades in the sun and is easily damaged when clearing snow.
Materials on site
Cement, mortars and adhesives in bags absorb moisture from the air and go lumpy even without direct rain. Keep them under a roof, on pallets and covered with sheeting. Lumpy cement cannot be used safely — it is better to buy less before winter and top up in spring.
Everything in buckets marked “protect from frost” — fillers, primers, paints, ready-mixed adhesives — needs to go into a heated room. A frozen dispersion usually does not recover its original properties.
Leave aerated concrete blocks in their factory wrap until you lay them. Protect mineral wool from water and polystyrene from sun and wind — light packs can blow off the site.
Water in the pipes
Turn off the water at the site connection and drain the pipes, the outdoor tap and the hoses. One frosty night is enough for a cracked valve to flood a trench or foundation.
Can you lay blocks and pour concrete in winter?
Most mortars and concretes need a temperature above +5°C while they set. There are admixtures and mortars for lower temperatures, but they only work within the range given on the product data sheet and do not replace protecting fresh masonry from frost. When working in the cold, cover new walls overnight and do not build onto frozen elements.
In the Suwałki region it is usually more sensible to plan a break and use the winter for work inside a heated building. In spring, before you go back to laying blocks, wait until the walls have thawed and dried out.
Checking the site after winter
Once the snow melts, walk round the site with a list before you start work again. Check that the sheeting on the wall tops is intact, that there are no damp stains in corners or under openings and that no water is standing by the foundations.
A wall that was wet all winter needs time to dry before you plaster it. Indoors, heating and a building dehumidifier help; outdoors, a few warm, dry days. Damp blocks under plaster are the most common cause of stains and plaster coming away in the first year.
